Resources

Soldering and Troubleshooting Tips

Soldering and Troubleshooting Tips 

Safety Precautions 

Safety should be your first priority when soldering. A soldering iron tip can reach temperatures that exceed 600 degrees Fahrenheit, so it is very important to avoid contact with any metal part of the iron. Unless the iron is in use it should always be positioned in the stand. Also keep the soldering iron electrical cord from contacting the iron while in the stand and during use, which could damage the cord and more importantly create an electrical shock hazard. Never leave the irons unattended and allow them to cool off properly before storing. 

Tinning 

An important step to good soldering is to prepare the soldering iron tip by a process called tinning. This should be done periodically with older iron tips and prior to using a new tip. While the iron is warming up, hold the solder against the tip and wait until the solder will begin to melt. As soon as the solder begins to melt, coat the tip surface completely and wipe the tip off with a wet sponge. The end result should be a thin layer of solder coating the tip. 

Soldering 

The soldering iron tip must be pressed against the circuit board joint and the component lead or wire to allow heating of both at the same time. Try to keep the iron at an angle of 30 to 40 degrees to the work. As the joint heats up, typically about 5 seconds or less, apply the solder at the point where the iron tip meets the work. Once the solder flows around the joint, remove the iron and let it cool. It is a good habitat to check all solder joints after they have cooled. A good solder joint should be smooth and shiny. Also the component should be rigidly attached at the joint to the board. The most common problems with soldering are adding too much or not enough solder. Using too much can cause a solder bridge. This simply means that two adjacent joints are contacting which results in a short circuit and the circuit not functioning properly. If not enough solder is used, the joint may not provide electrical continuity between the board and component. A desoldering iron, “Solder Sucker”, can be used to correct improper connections and also remove circuit components that are positioned incorrectly on the board. 

About JY Electronic®

JY Electronic® is the established leader in providing innovative and reliable PCB & PCBA solutions for the electronic design industry. With over 20 years of experience in supplying high quality, on-time PCB & PCBA prototypes and mass production, JY Electronic is committed to improving production process for the design engineer from quote to delivery.  JY Electronic provides unparalleled customer service and leads the industry with a real On-Time Guarantee that is the first of its kind. For more information about JY's innovative PCB & PCBA solutions, or to learn more about quote and ordering process, please visit www.JYcircuitboard.com 

 

| hydrogen water maker | | Hybrid PCB | | Laser safety glasses | | dress head | | Treatment of kidney failure | | Laser safety goggle | | pcb assembly | | PCB Equipment | xlpe Power Cable | Crusher Plant | xfp module